MC908GR32AVFAE Datasheet, PDF (162/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Enhanced Serial Communications Interface (ESCI) Module
actual stop bit. Then a noise error occurs. If more than one of the samples is outside the stop bit, a framing
error occurs. In most applications, the baud rate tolerance is much more than the degree of misalignment
that is likely to occur.
As the receiver samples an incoming character, it resynchronizes the RT clock on any valid falling edge
within the character. Resynchronization within characters corrects misalignments between transmitter bit
times and receiver bit times.
Slow Data Tolerance
Figure 13-8 shows how much a slow received character can be misaligned without causing a noise error
or a framing error. The slow stop bit begins at RT8 instead of RT1 but arrives in time for the stop bit data
samples at RT8, RT9, and RT10.
MSB
STOP
RECEIVER
RT CLOCK
DATA
SAMPLES
Figure 13-8. Slow Data
For an 8-bit character, data sampling of the stop bit takes the receiver 9 bit times × 16 RT cycles
+ 10 RT cycles = 154 RT cycles.
With the misaligned character shown in Figure 13-8, the receiver counts 154 RT cycles at the point when
the count of the transmitting device is 9 bit times × 16 RT cycles + 3 RT cycles = 147 RT cycles.
The maximum percent difference between the receiver count and the transmitter count of a slow 8-bit
character with no errors is:
-1---5---4-----^–----1----4---7-- ^{× 100 = 4.54%}
154
For a 9-bit character, data sampling of the stop bit takes the receiver 10 bit times × 16 RT cycles
+ 10 RT cycles = 170 RT cycles.
With the misaligned character shown in Figure 13-8, the receiver counts 170 RT cycles at the point when
the count of the transmitting device is 10 bit times × 16 RT cycles + 3 RT cycles = 163 RT cycles.
The maximum percent difference between the receiver count and the transmitter count of a slow 9-bit
character with no errors is:
-1---7---0-----^–----1----6---3-- ^{× 100 = 4.12%}
170
Fast Data Tolerance
Figure 13-9 shows how much a fast received character can be misaligned without causing a noise error
or a framing error. The fast stop bit ends at RT10 instead of RT16 but is still there for the stop bit data
samples at RT8, RT9, and RT10.
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
162
Freescale Semiconductor