MC908GR32AVFAE Datasheet, PDF (220/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Serial Peripheral Interface (SPI) Module
If the MODFEN bit is 0, the level of the SS pin does not affect the operation of an enabled SPI
configured as a master. For an enabled SPI configured as a slave, having MODFEN low only prevents
the MODF flag from being set. It does not affect any other part of SPI operation. See 15.6.2 Mode Fault
Error.
SPR1 and SPR0 — SPI Baud Rate Select Bits
In master mode, these read/write bits select one of four baud rates as shown in Table 15-3. SPR1 and
SPR0 have no effect in slave mode. Reset clears SPR1 and SPR0.
Table 15-3. SPI Master Baud Rate Selection
SPR1 and SPR0
00
01
10
11
Baud Rate Divisor (BD)
2
8
32
128
Use this formula to calculate the SPI baud rate:
Baud rate = ^BUSCLK
BD
15.12.3 SPI Data Register
The SPI data register consists of the read-only receive data register and the write-only transmit data
register. Writing to the SPI data register writes data into the transmit data register. Reading the SPI data
register reads data from the receive data register. The transmit data and receive data registers are
separate registers that can contain different values. See Figure 15-2.
Address: $0012
Bit 7
6
5
4
3
2
1
Bit 0
Read: R7
R6
R5
R4
R3
R2
R1
R0
Write: T7
T6
T5
T4
T3
T2
T1
T0
Reset:
Unaffected by reset
Figure 15-16. SPI Data Register (SPDR)
R7–R0/T7–T0 — Receive/Transmit Data Bits
NOTE
Do not use read-modify-write instructions on the SPI data register since the
register read is not the same as the register written.
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
220
Freescale Semiconductor