CC2510FX Datasheet, PDF (82/253 Pages) List of Unclassifed Manufacturers – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

CC2510Fx / CC2511Fx
PICTL (0x8C) – Port Interrupt Control
Bit Name
7_-
6_-
5 _P2IEN
4 _P0IENH
3 _P0IENL
2 _P2ICON
1 _P1ICON
0 _P0ICON
Reset R/W
0
R0
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
Description
Not used
Reserved. Write 0
Port 2, inputs 4 to 0 interrupt enable. This bit enables interrupt
requests for the port 2 inputs 4 to 0.
0 Interrupts are disabled
1 Interrupts are enabled
Port 0, inputs 7 to 4 interrupt enable. This bit enables interrupt
requests for the port 0 inputs 7 to 4.
0 Interrupts are disabled
1 Interrupts are enabled
Port 0, inputs 3 to 0 interrupt enable. This bit enables interrupt
requests for the port 0 inputs 3 to 0.
0 Interrupts are disabled
1 Interrupts are enabled
Port 2, inputs 4 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 2 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
Port 1, inputs 7 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 1 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
Port 0, inputs 7 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 0 inputs. For CC2511Fx this bit
must not be set to 1 when USB is used, since the internal USB
resume interrupt mapped to P0[7] uses rising edge.
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
CC2510Fx/CC2511Fx PRELIMINARY Data Sheet (Rev. 1.2) SWRS055A Page 82 of 252