CC2510FX Datasheet, PDF (8/253 Pages) List of Unclassifed Manufacturers – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

CC2510Fx / CC2511Fx
4 Features (continued from front page)
4.1 High-Performance and Low-Power
8051-Compatible Microcontroller
• Optimized 8051 core which typically gives
8x the performance of a standard 8051
• Support for µ-law compression and
expansion
• Typically used to connect to external DAC
or ADC.
• Dual data pointers
4.5 Hardware AES Encryption/Decryption
• In-circuit interactive debugging is
supported for the IAR Embedded
Workbench through a simple two-wire
serial interface
• 128-bit AES supported in hardware
coprocessor
4.6 Peripheral Features
4.2 8/16/32 kB Non-volatile Program
Memory and 1/2/4 kB Data Memory
• 8, 16 or 32 kB of non-volatile Flash
memory, in-system programmable through
a simple two-wire interface or by the 8051
core
• Worst case flash memory endurance:
1000 write/erase cycles (applies per bit
cell).
• Programmable read and write lock of
portions of Flash memory for software
security
• 1, 2 or 4 kB of internal SRAM
4.3 Full-Speed USB Controller (CC2511Fx )
• 5 bi-directional endpoints in addition to
control endpoint 0
• Full-Speed, 12 Mbps transfer rate.
• Support for Bulk, Interrupt and
Isochronous endpoints
• 1024 bytes of dedicated endpoint FIFO
memory.
• 8 – 512 byte data packet size supported
• Configurable FIFO size for IN and OUT
direction of endpoint
4.4 I2S Interface
• Industry standard I2S interface for transfer
of digital audio data
• Full duplex
• Powerful DMA Controller
• Power On Reset
• Battery monitor
• Eight channel, 8-14 bit ADC
• Programmable watchdog timer
• Real time clock with 32.768 kHz crystal
oscillator
• Four timers: one general 16-bit timer, two
general 8-bit timers, one MAC timer. The
16-bit timer can also be used in Delta-
Sigma Modulator (DSM) mode. This
allows the timer to produce a high quality
audio output signal that only requires a
low-cost passive external filter.
• Two programmable USARTs for
master/slave SPI or UART operation
• Up to 21 configurable general-purpose
digital I/O-pins (CC2511Fx has 19 general-
purpose digital I/O-pins)
• Random number generator
4.7 Low Power
• Four flexible power modes for reduced
power consumption
• Only 0.5 µA current consumption in
standby mode, where external interrupts
or the real-time counter can wake up the
system
• 0.3 µA current consumption in power down
mode, where external interrupts can wake
up the system
• Mono and stereo support
• Configurable sample rate and sample size
• System can wake up on external interrupt
or real-time counter event
CC2510Fx/CC2511Fx PRELIMINARY Data Sheet (Rev. 1.2) SWRS055A Page 8 of 252