DS80C390_00 Datasheet, PDF (90/155 Pages) Dallas Semiconductor – High-Speed Microcontroller User’s Guide Supplement

DS80C390 High-Speed Microcontroller User’s Guide Supplement
CAN 1 Message Center 1 Control Register (C1M1C)
7
6
5
4
3
2
1
0
SFR EBh MSRDY ETI
ERI INTRQ EXTRQ MTRQ ROW/TIH DTUP
RW-0 RW-0 RW-0 RW-0 RC-0
R*-0
R*-0
R*-0
R=Unrestricted Read, C=Clear Only, *= See description below, -n=Value after Reset
MSRDY
Bit 7
ETI
Bit 6
ERI
Bit 5
INTRQ
Bit 4
EXTRQ
Bit 3
CAN 1 Message Center 1 Ready. This bit is used by the Microcontroller to
prevent the CAN module from accessing message center 1 while the
microcontroller is updating message attributes. These include as identifiers
(arbitration registers 0-3), data byte registers 0-7, data byte count (DTBYC3-
DTBYC1), direction control (T/ R ), the extended or standard mode bit
(EX/ST), and the mask enables (MEME and MDME) associated with this
message center. When this bit is 0, the CAN 1 processor will ignore this
message center for transmit, receive, or remote frame request operations.
MSRDY is cleared following a microcontroller hardware reset or a reset
generated by the CRST bit in the CAN 1 Control Register, and must also
remain in a cleared mode until all the CAN 1 initialization has been
completed. Individual message MSRDY controls can be changed after
initialization to reconfigure specific messages, without interrupting the
communication of other messages on the CAN 1 Bus.
CAN 1 Message Center 1 Enable Transmit Interrupt. Setting ETI to a 1
will enable a successful CAN 1 transmission in message center 1 to set the
INTRQ bit for this message center which in turn will issue an interrupt to the
microcontroller. When ETI is cleared to 0 a successful transmission will not
set INTRQ bit and will not generate an interrupt. Note that the ETI bit located
in Message Center 15 is ignored by the CAN module, since the message
center 15 is a receive only message center.
CAN 1 Message Center 1 Enable Receive Interrupt. Setting ERI to a 1
will enable a successful CAN 1 reception and storage in message center 1 to
set the INTRQ bit for this message center which in turn will issue an interrupt
to the microcontroller. When ERI is cleared to 0 a successful reception will
not set the INTRQ bit and as such will not generate an interrupt.
CAN 1 Message Center 1 Interrupt Request. This bit serves as a CAN
interrupt flag, indicating the successful transmission or reception of a
message in this message center. INTRQ is automatically set when ERI=1 and
message center 1 successfully receives and stores a message. The INTRQ bit
is also set to a 1 when ETI is set and the CAN 1 logic completes a successful
transmission. The INTRQ interrupt request must be also enabled via the EA
global mask in the IE SFR register if the interrupt is to be acknowledged by
the microcontroller interrupt logic. This flag must be cleared via software.
CAN 1 Message Center 1 External Transmit Request. When EXTRQ is
cleared to a 0, there are no pending requests by external CAN nodes for this
message. When EXTRQ is set to a 1, a request has been made for this
message by an external CAN node, but the CAN 1 controller has not yet
90 of 155