PIC18F4321 Datasheet, PDF (338/396 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

PIC18F4321 FAMILY
26.2 DC Characteristics: Power-Down and Supply Current
PIC18F2221/2321/4221/4321 (Industrial)
PIC18LF2221/2321/4221/4321 (Industrial) (Continued)
PIC18LF2221/2321/4221/4321
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
PIC18F2221/2321/4221/4321
(Industrial, Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Device
Typ Max Units
Conditions
Legend:
Note 1:
2:
3:
4:
Supply Current (IDD)⁽²⁾
All devices 8
7
7
Extended devices only 8
16 mA
16 mA
16 mA
25 mA
-40°C
+25°C
+85°C
+125°C
VDD = 4.2V
FOSC = 4 MHz,
16 MHz internal
(PRI_RUN HS+PLL)
All devices 10
10
10
Extended devices only 10
21 mA
21 mA
21 mA
35 mA
-40°C
+25°C
+85°C
+125°C
VDD = 5.0V
FOSC = 4 MHz,
16 MHz internal
(PRI_RUN HS+PLL)
All devices 17
17
17
35 mA
35 mA
35 mA
-40°C
+25°C
+85°C
VDD = 4.2V
FOSC = 10 MHz,
40 MHz internal
(PRI_RUN HS+PLL)
All devices 23
23
23
40 mA
40 mA
40 mA
-40°C
+25°C
+85°C
VDD = 5.0V
FOSC = 10 MHz,
40 MHz internal
(PRI_RUN HS+PLL)
Shading of rows is to assist in readability of the table.
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured
with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS and all features that
add delta current disabled (such as WDT, Timer1 Oscillator, BOR, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin
loading and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have
an impact on the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD or VSS;
MCLR = VDD; WDT enabled/disabled as specified.
Low-power Timer1 oscillator selected.
BOR and HLVD enable internal band gap reference. With both modules enabled, current consumption will be less
than the sum of both specifications.
DS39689E-page 336
Preliminary
© 2007 Microchip Technology Inc.