PIC18F45J10 Datasheet, PDF (307/358 Pages) Microchip Technology – 28/40/44-Pin High-Performance RISC Microcontrollers with nanoWatt Technology

PIC18F45J10 FAMILY
23.3 DC Characteristics: PIC18F45J10 family (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VIL
D030
D030A
D031
Input Low Voltage
All I/O ports:
with TTL buffer
with Schmitt Trigger buffer
VSS
0.15 VDD V VDD < 3.3V
—
0.8
V 3.3V ≤ VDD ≤ 3.6V
VSS
0.2 VDD V
D032
D033
D033A
MCLR
OSC1
OSC1
VSS
0.2 VDD V
VSS
0.3 VDD V HS, HSPLL modes
VSS
0.2 VDD V EC, ECPLL modes⁽¹⁾
D034
VIH
D040
D040A
D041
Dxxx
DxxxA
Dxxx
T1CKI
VSS
0.3
Input High Voltage
I/O ports with analog functions:
with TTL buffer
0.25 VDD + 0.8V VDD
2.0
VDD
with Schmitt Trigger buffer
0.8 VDD
VDD
Digital-only I/O ports:
with TTL buffer
0.25 VDD + 0.8V 5.5
2.0
5.5
with Schmitt Trigger buffer
0.8 VDD
5.5
V
V VDD < 3.3V
V 3.3V ≤ VDD ≤ 3.6V
V
V VDD < 3.3V
V 3.3V ≤ VDD ≤ 3.6V
V
D042
D043
D043A
MCLR
OSC1
OSC1
0.8 VDD
0.7 VDD
0.8 VDD
VDD
V
VDD
V HS, HSPLL modes
VDD
V EC, ECPLL modes
D044
T1CKI
1.6
VDD
V
IIL
Input Leakage Current^(2,3)
D060
I/O ports
—
±1
μA VSS ≤ VPIN ≤ VDD,
Pin at high-impedance
D061
MCLR
—
±1
μA Vss ≤ VPIN ≤ VDD
D063
OSC1
—
±5
μA Vss ≤ VPIN ≤ VDD
IPU
Weak Pull-up Current
D070 IPURB PORTB weak pull-up current
30
240
μA VDD = 3.3V, VPIN = VSS
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
© 2007 Microchip Technology Inc.
Preliminary
DS39682C-page 305