PIC18F45J10 Datasheet, PDF (301/358 Pages) Microchip Technology – 28/40/44-Pin High-Performance RISC Microcontrollers with nanoWatt Technology

PIC18F45J10 FAMILY
23.2 DC Characteristics: Power-Down and Supply Current
PIC18F24J10/25J10/44J10/45J10 (Industrial)
PIC18LF24J10/25J10/44J10/45J10 (Industrial) (Continued)
PIC18F45J10 Family
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
Param
No.
Device
Typ Max Units
Conditions
Supply Current (IDD)⁽²⁾
All devices 3.8 7.7 mA
-40°C
3.7 7.5 mA
3.7 7.5 mA
All devices 3.9 7.9 mA
3.7 7.5 mA
+25°C
+85°C
-40°C
+25°C
VDD = 2.5V
VDD = 3.3V
FOSC = 31 kHz
(RC_RUN mode,
Internal oscillator source)
3.7 7.5 mA
+85°C
All devices 64 167 μA
-40°C
77 193 μA
95 269 μA
All devices 65 266 μA
79 294 μA
98 360 μA
+25°C
+85°C
-40°C
+25°C
+85°C
VDD = 2.5V
VDD = 3.3V
FOSC = 31 kHz
(RC_IDLE mode,
Internal oscillator source)
Note 1:
2:
3:
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS and all features that add delta
current disabled (such as WDT, Timer1 oscillator, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
© 2007 Microchip Technology Inc.
Preliminary
DS39682C-page 299