PIC18F45J10 Datasheet, PDF (124/358 Pages) Microchip Technology – 28/40/44-Pin High-Performance RISC Microcontrollers with nanoWatt Technology

PIC18F45J10 FAMILY
12.2 Timer2 Interrupt
Timer2 can also generate an optional device interrupt.
The Timer2 output signal (TMR2-to-PR2 match) pro-
vides the input for the 4-bit output counter/postscaler.
This counter generates the TMR2 match interrupt flag
which is latched in TMR2IF (PIR1<1>). The interrupt is
enabled by setting the TMR2 Match Interrupt Enable
bit, TMR2IE (PIE1<1>).
A range of 16 postscale options (from 1:1 through 1:16
inclusive) can be selected with the postscaler control
bits, T2OUTPS3:T2OUTPS0 (T2CON<6:3>).
FIGURE 12-1:
TIMER2 BLOCK DIAGRAM
4
T2OUTPS3:T2OUTPS0
2
T2CKPS1:T2CKPS0
FOSC/4
1:1, 1:4, 1:16
Prescaler
Internal Data Bus
Reset
TMR2
8
12.3 Timer2 Output
The unscaled output of TMR2 is available primarily to
the CCP modules, where it is used as a time base for
operations in PWM mode.
Timer2 can be optionally used as the shift clock source
for the MSSP module operating in SPI mode.
Additional information is provided in Section 15.0
“Master Synchronous Serial Port (MSSP) Module”.
1:1 to 1:16
Postscaler
TMR2/PR2
Match
Comparator
8
Set TMR2IF
TMR2 Output
(to PWM or MSSP)
PR2
8
TABLE 12-1: REGISTERS ASSOCIATED WITH TIMER2 AS A TIMER/COUNTER
Name Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Reset
Values
on page
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE
RBIE TMR0IF INT0IF RBIF
43
PIR1
PSPIF⁽¹⁾
ADIF
RCIF
TXIF
SSP1IF CCP1IF TMR2IF TMR1IF 45
PIE1
PSPIE⁽¹⁾ ADIE
RCIE
TXIE
SSP1IE CCP1IE TMR2IE TMR1IE
45
IPR1
PSPIP⁽¹⁾ ADIP
RCIP
TXIP
SSP1IP CCP1IP TMR2IP TMR1IP
45
TMR2 Timer2 Register
44
T2CON
— T2OUTPS3 T2OUTPS2 T2OUTPS1 T2OUTPS0 TMR2ON T2CKPS1 T2CKPS0 44
PR2 Timer2 Period Register
44
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used by the Timer2 module.
Note 1: These bits are not implemented on 28-pin devices and should be read as ‘0’.
DS39682C-page 122
Preliminary
© 2007 Microchip Technology Inc.