PIC18F45J10 Datasheet, PDF (127/358 Pages) Microchip Technology – 28/40/44-Pin High-Performance RISC Microcontrollers with nanoWatt Technology

PIC18F45J10 FAMILY
13.2 Capture Mode
In Capture mode, the CCPRxH:CCPRxL register pair
captures the 16-bit value of the TMR1 register when an
event occurs on the corresponding CCPx pin. An event
is defined as one of the following:
• every falling edge
• every rising edge
• every 4th rising edge
• every 16th rising edge
The event is selected by the mode select bits,
CCPxM3:CCPxM0 (CCPxCON<3:0>). When a capture
is made, the interrupt request flag bit, CCPxIF, is set; it
must be cleared in software. If another capture occurs
before the value in register CCPRx is read, the old
captured value is overwritten by the new captured value.
13.2.1 CCP PIN CONFIGURATION
In Capture mode, the appropriate CCPx pin should be
configured as an input by setting the corresponding
TRIS direction bit.
Note:
If RB3/CCP2 or RC1/CCP2 is configured
as an output, a write to the port can cause
a capture condition.
13.2.2 SOFTWARE INTERRUPT
When the Capture mode is changed, a false capture
interrupt may be generated. The user should keep the
CCPxIE interrupt enable bit clear to avoid false inter-
rupts. The interrupt flag bit, CCPxIF, should also be
cleared following any such change in operating mode.
13.2.3 CCP PRESCALER
There are four prescaler settings in Capture mode; they
are specified as part of the operating mode selected by
the mode select bits (CCPxM3:CCPxM0). Whenever
the CCP module is turned off or Capture mode is
disabled, the prescaler counter is cleared. This means
that any Reset will clear the prescaler counter.
Switching from one capture prescaler to another may
generate an interrupt. Also, the prescaler counter will
not be cleared; therefore, the first capture may be from
a non-zero prescaler. Example 13-1 shows the
recommended method for switching between capture
prescalers. This example also clears the prescaler
counter and will not generate the “false” interrupt.
EXAMPLE 13-1:
CHANGING BETWEEN
CAPTURE PRESCALERS
(CCP2 SHOWN)
CLRF CCP2CON
MOVLW NEW_CAPT_PS
MOVWF CCP2CON
; Turn CCP module off
; Load WREG with the
; new prescaler mode
; value and CCP ON
; Load CCP2CON with
; this value
FIGURE 13-1:
CAPTURE MODE OPERATION BLOCK DIAGRAM
CCP1 pin
Prescaler
÷ 1, 4, 16
Set CCP1IF
and
Edge Detect
CCP1CON<3:0> ⁴
Q1:Q4 ⁴
CCP2CON<3:0> ⁴
Set CCP2IF
CCPR1H CCPR1L
TMR1H TMR1L
CCP2 pin
Prescaler
÷ 1, 4, 16
and
Edge Detect
CCPR2H CCPR2L
TMR1H TMR1L
© 2007 Microchip Technology Inc.
Preliminary
DS39682C-page 125