English
Language : 

PIC18F-LF1XK50 Datasheet, PDF (289/420 Pages) Microchip Technology – 20-Pin USB Flash Microcontrollers
PIC18F/LF1XK50
TABLE 23-4: INITIALIZATION CONDITIONS FOR ALL REGISTERS (CONTINUED)
Register
Address
Power-on Reset,
Brown-out Reset
MCLR Resets,
WDT Reset,
RESET Instruction,
Stack Resets
Wake-up via WDT
or Interrupt
USTAT
UIR
UCFG
UIE
UEIR
UFRMH
UFRML
UADDR
UEIE
UEP7
UEP6
UEP5
UEP4
UEP3
UEP2
UEP1
UEP0
Legend:
Note 1:
2:
3:
4:
5:
F63h
-xxx xxx-
-xxx xxx-
-uuu uuu-
F62h
-000 0000
-000 0000
-uuu uuuu
F61h
0--0 -000
0--0 -000
u--u -uuu
F60h
-000 0000
-000 0000
-uuu uuuu
F5Fh
0--0 0000
0--0 0000
u--u uuuu
F5Eh
---- -xxx
---- -xxx
---- -uuu
F5Dh
xxxx xxxx
xxxx xxxx
uuuu uuuu
F5Ch
-000 0000
-000 0000
-uuu uuuu
F5Bh
0--0 0000
0--0 0000
u--u uuuu
F5Ah
----0 0000
----0 0000
----u uuuu
F59h
----0 0000
----0 0000
----u uuuu
F58h
----0 0000
----0 0000
----u uuuu
F57h
----0 0000
----0 0000
----u uuuu
F56h
----0 0000
----0 0000
----u uuuu
F55h
----0 0000
----0 0000
----u uuuu
F54h
----0 0000
----0 0000
----u uuuu
F53h
----0 0000
----0 0000
----u uuuu
u = unchanged, x = unknown, - = unimplemented bit, read as ‘0’, q = value depends on condition.
Shaded cells indicate conditions do not apply for the designated device.
One or more bits in the INTCONx or PIRx registers will be affected (to cause wake-up).
When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the PC is loaded with the interrupt
vector (0008h or 0018h).
When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the TOSU, TOSH and TOSL are
updated with the current value of the PC. The STKPTR is modified to point to the next location in the hard-
ware stack.
See Table 23-3 for Reset value for specific condition.
All bits of the ANSELH register initialize to ‘0’ if the PBADEN bit of CONFIG3H is ‘0’.
 2010 Microchip Technology Inc.
Preliminary
DS41350E-page 289