PIC18F-LF1XK50 Datasheet, PDF (112/420 Pages) Microchip Technology – 20-Pin USB Flash Microcontrollers

PIC18F/LF1XK50
12.2 Timer2 Interrupt
Timer2 can also generate an optional device interrupt.
The Timer2 output signal (TMR2-to-PR2 match) pro-
vides the input for the 4-bit output counter/postscaler.
This counter generates the TMR2 match interrupt flag
which is latched in TMR2IF of the PIR1 register. The
interrupt is enabled by setting the TMR2 Match Inter-
rupt Enable bit, TMR2IE of the PIE1 register.
A range of 16 postscale options (from 1:1 through 1:16
inclusive) can be selected with the postscaler control
bits, T2OUTPS<3:0> of the T2CON register.
FIGURE 12-1:
TIMER2 BLOCK DIAGRAM
T2OUTPS<3:0>
T2CKPS<1:0>
FOSC/4
4
2
1:1, 1:4, 1:16
Prescaler
Internal Data Bus
Reset
TMR2
8
12.3 Timer2 Output
The unscaled output of TMR2 is available primarily to
the CCP modules, where it is used as a time base for
operations in PWM mode.
Timer2 can be optionally used as the shift clock source
for the MSSP module operating in SPI mode. Addi-
tional information is provided in Section 14.0 “Master
Synchronous Serial Port (MSSP) Module”.
1:1 to 1:16
Postscaler
TMR2/PR2
Match
Comparator
8
Set TMR2IF
TMR2 Output
(to PWM or MSSP)
PR2
8
TABLE 12-1: REGISTERS ASSOCIATED WITH TIMER2 AS A TIMER/COUNTER
Name Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Reset
Values
on page
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE RABIE TMR0IF INT0IF RABIF
285
PIR1
—
ADIF
RCIF
TXIF
SSPIF CCP1IF TMR2IF TMR1IF 288
PIE1
—
ADIE
RCIE
TXIE
SSPIE CCP1IE TMR2IE TMR1IE 288
IPR1
—
ADIP
RCIP
TXIP
SSPIP CCP1IP TMR2IP TMR1IP 288
TMR2 Timer2 Register
286
T2CON
— T2OUTPS3 T2OUTPS2 T2OUTPS1 T2OUTPS0 TMR2ON T2CKPS1 T2CKPS0 286
PR2 Timer2 Period Register
286
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used by the Timer2 module.
DS41350E-page 112
Preliminary
 2010 Microchip Technology Inc.