PIC18F-LF1XK50 Datasheet, PDF (229/420 Pages) Microchip Technology – 20-Pin USB Flash Microcontrollers

PIC18F/LF1XK50
REGISTER 18-1: CM1CON0: COMPARATOR 1 CONTROL REGISTER 0
R/W-0
C1ON
bit 7
R-0
C1OUT
R/W-0
C1OE
R/W-0
C1POL
R/W-0
C1SP
R/W-0
C1R
R/W-0
C1CH1
R/W-0
C1CH0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1-0
C1ON: Comparator C1 Enable bit
1 = Comparator C1 is enabled
0 = Comparator C1 is disabled
C1OUT: Comparator C1 Output bit
If C1POL = 1 (inverted polarity):
C1OUT = 0 when C1VIN+ > C1VIN-
C1OUT = 1 when C1VIN+ < C1VIN-
If C1POL = 0 (non-inverted polarity):
C1OUT = 1 when C1VIN+ > C1VIN-
C1OUT = 0 when C1VIN+ < C1VIN-
C1OE: Comparator C1 Output Enable bit
If C2OE = 0 (C2 output disable)
0 = C1OUT is internal only
1 = C1OUT is present on the C12OUT pin⁽¹⁾
If C2OE = 1 (C2 output enable)
0 = C1OUT is internal only
1 = C2OUT is present on the C12OUT pin⁽¹⁾
C1POL: Comparator C1 Output Polarity Select bit
1 = C1OUT logic is inverted
0 = C1OUT logic is not inverted
C1SP: Comparator C1 Speed/Power Select bit
1 = C1 operates in normal power, higher speed mode
0 = C1 operates in low-power, low-speed mode
C1R: Comparator C1 Reference Select bit (non-inverting input)
1 = C1VIN+ connects to C1VREF output
0 = C1VIN+ connects to C12IN+ pin
C1CH<1:0>: Comparator C1 Channel Select bit
00 = C1VIN- connects to AGND
01 = C12IN1- pin of C1 connects to C1VIN-
10 = C12IN2- pin of C1 connects to C1VIN-
11 = C12IN3- pin of C1 connects to C1VIN-
Note 1: Comparator output requires the following three conditions: C1OE = 1, C1ON = 1 and corresponding port
TRIS bit = 0.
 2010 Microchip Technology Inc.
Preliminary
DS41350E-page 229