PIC32MX5XX_11 Datasheet, PDF (249/256 Pages) Microchip Technology – High-Performance, USB, CAN and Ethernet 32-bit Flash Microcontrollers

PIC32MX5XX/6XX/7XX
Revision G (May 2011)
The revision includes the following global update:
• All references to VDDCORE/VCAP have been
changed to: VCORE/VCAP
• Added references to the new V-Temp temperature
range: -40ºC to +105ºC
This revision also includes minor typographical and
formatting changes throughout the data sheet text.
Major updates are referenced by their respective
section in the following table.
TABLE B-5: MAJOR SECTION UPDATES
Section Name
Update Description
High-Performance, USB, CAN and
Removed the shading for all D- and D+ pins in all pin diagrams.
Ethernet 32-bit Flash Microcontrollers
1.0 “Device Overview”
Updated the VBUS description in Table 1-1.
2.0 “Guidelines for Getting Started with Added 2.11 “Referenced Sources”.
32-bit Microcontrollers”
4.0 “Memory Organization”
Added Note 3 to the Interrupt Register Map tables (see Table 4-2 through
Table 4-7.
22.0 “10-bit Analog-to-Digital Converter Updated the ADC Conversion Clock Period Block Diagram (see
(ADC)”
Figure 22-2).
26.0 “Comparator Voltage Reference
(CVREF)”
Updated the Comparator Voltage Reference Block Diagram (see
Figure 26-1).
28.0 “Special Features”
Removed the second paragraph from 28.3.1 “On-Chip Regulator and
POR”.
31.0 “Electrical Characteristics”
Added the new V-Temp temperature range (-40ºC to +105ºC) to the
heading of all specification tables.
Updated the Ambient temperature under bias, updated the Voltage on
any 5V tolerant pin with respect to VSS when VDD < 2.3V, and added
Voltage on VBUS with respect to Vss in Absolute Maximum Ratings.
Added the characteristic, DC5a to Operating MIPS vs. Voltage (see
Table 31-1).
Updated or added the following parameters to the Operating Current
(IDD) DC Characteristics: DC20, DC20b, DC23, and DC23b (see
Table 31-5).
Added the following parameters to the Idle Current (IIDLE) DC
Characteristics: DC30b, DC33b, DC34c, DC35c, and DC36c (see
Table 31-6).
Added the following parameters to the Power-down Current (IPD) DC
Characteristics: DC40g, DC40h, DC40i, and DC41g, (see Table 31-7).
Added parameter IM51 and Note 3 to the I2Cx Bus Data Timing
Requirements (Master Mode) (see Table 31-32).
Updated the 10-bit ADC Conversion Rate Parameters (see Table 31-37).
32.0 “Packaging Information”
Product Identification System
Updated parameter AD57 (TSAMP) in the Analog-to-Digital Conversion
Timing Requirements (see Table 31-38).
Updated the 64-Lead Plastic Quad Flat, No Lead Package (MR) –
9x9x0.9 mm Body [QFN] packing diagram.
Added the new V-Temp (V) temperature information.
© 2009-2011 Microchip Technology Inc.
DS61156G-page 249