IA186EM_11 Datasheet, PDF (84/146 Pages) InnovASIC, Inc – 8-Bit/16-Bit Microcontrollers

IA186EM/IA188EM
8-Bit/16-Bit Microcontrollers
Data Sheet
February 25, 2011
Values of PR2–PR0 by Priority
Priority PR2–PR0
(High) 0 000b
1
001b
2
010b
3
011b
4
100b
5
101b
6
110b
(Low) 7 111b
5.1.32 WDCON (044h) (Master Mode)
WatchDog Timer Interrupt CONtrol Register. These registers control the operation of the
Watchdog Timer interrupt source. The value of this register is 000Fh at reset (see Table 54).
Table 54. Watchdog Timer Interrupt Control Register
15 14 13 12 11 10 9 8 7 6 5
4
3 210
Reserved
Reserved MSK PR2–PR0
Bits [15–5]—Reserved → Set to 0.
Bit [4]—Reserved → Set to 0.
Bit [3]—MSK Mask → This bit, when 0, enables the Watchdog Timer to cause an
interrupt. When this bit is 1 prevents the Watchdog Timer from generating an interrupt.
Bits [2–0]—PR2–PR0 Priority → These bits define the priority of the Watchdog Timer
interrupt in relation to other interrupt signals. The interrupt priority is the lowest at 7 at
reset. The values of PR2–PR0 are shown in the above table.
5.1.33 I4CON (040h) (Master Mode)
This register controls the operation of the int4 signal, which is only intended for use in fully
nested mode. The interrupt is assigned to type 10h. The value of the I4CON register is 000Fh at
reset (see Table 55).
Table 55. INT4 Control Register
15 14 13 12 11 10 9 8 7 6 5 4
3 210
Reserved
LTM MSK PR2–PR0
®
IA211050831-19
http://www.Innovasic.com
UNCONTROLLED WHEN PRINTED OR COPIED
Customer Support:
Page 84 of 146
1-888-824-4184