IA186EM_11 Datasheet, PDF (34/146 Pages) InnovASIC, Inc – 8-Bit/16-Bit Microcontrollers

IA186EM/IA188EM
8-Bit/16-Bit Microcontrollers
Data Sheet
February 25, 2011
The select_n pin provides an indication to the microcontroller that an interrupt type has been
placed on the address/data bus when the internal Interrupt Control Unit is slaved to an external
interrupt controller. Before this can occur, however, the int0 pin must have already indicated an
interrupt request has occurred.
2.2.18 int2/inta0_n/pio31—Maskable Interrupt Request 2 (asynchronous input)/Interrupt
Acknowledge 0 (synchronous output)
The int2 pin provides an indication that an interrupt request has occurred, and provided that int2
is not masked, program execution will continue at the location specified by the int2 vector in the
interrupt vector table. Although interrupt requests are asynchronous, they are synchronized
internally and may be edge- or level-triggered. To ensure that it is recognized, the assertion of
the interrupt request must be maintained until it is handled. When int0 is configured to be in
cascade mode, int2 changes its function to inta0_n.
The inta0_n function indicates to the system that the microcontroller requires an interrupt type in
response to the interrupt request int0 when the microcontroller’s Interrupt Control Unit is in
cascade mode. The peripheral device that issued the interrupt must provide the interrupt type.
2.2.19 int3/inta1_n/irq—Maskable Interrupt Request 3 (asynchronous input)/Interrupt
Acknowledge 1 (synchronous output)/Interrupt Acknowledge (synchronous
output)
The int3 pin provides an indication that an interrupt request has occurred. If int3 is not masked,
program execution will continue at the location specified by the int3 vector in the interrupt
vector table. Although interrupt requests are asynchronous, they are synchronized internally and
may be edge- or level-triggered. To ensure that it is recognized, the assertion of the interrupt
request must be maintained until it is handled. When int1 is configured to be in cascade mode,
int3 changes its function to inta1_n.
The inta1_n function indicates to the system that the microcontroller requires an interrupt type in
response to the interrupt request int1 when the microcontroller’s Interrupt Control Unit is in
cascade mode. The peripheral device that issued the interrupt must provide the interrupt type.
The signal on irq allows the microcontroller to output an interrupt request to the external master
interrupt controller when the Interrupt Control Unit of the microcontroller is in slave mode.
2.2.20 int4/pio30—Maskable Interrupt Request 4 (asynchronous input)
The int4 pin provides an indication that an interrupt request has occurred, and provided that int4
is not masked, program execution will continue at the location specified by the int4 vector in the
interrupt vector table. Although interrupt requests are asynchronous, they are synchronized
internally and may be edge- or level-triggered. To ensure that it is recognized, the assertion of
the interrupt request must be maintained until it is handled.
®
IA211050831-19
http://www.Innovasic.com
UNCONTROLLED WHEN PRINTED OR COPIED
Customer Support:
Page 34 of 146
1-888-824-4184