IA186EM_11 Datasheet, PDF (62/146 Pages) InnovASIC, Inc – 8-Bit/16-Bit Microcontrollers

IA186EM/IA188EM
8-Bit/16-Bit Microcontrollers
Data Sheet
February 25, 2011
Table 22. Count for Dynamic RAM Refresh Control Register
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reserved
RC8–RC0
Bits [15–9]—Reserved → These bits read back as 0.
Bits [8–0]—RC8–RC0 → These bits hold the clock count interval between refresh
cycles. In power-save mode, the refresh counter value should be adjusted to account for
the clock divider value in PDCON.
Note: This value should not be set to less than 18 (12h), else there would
never be sufficient bus cycles available for the processor to execute code.
5.1.7 MDRAM (0e0h)
The Memory Partition Register holds the a19–a13 address bits of the 20-bit base refresh address.
The MDRAM register contains 0000h at reset (see Table 23).
Table 23. Memory Partition for Dynamic RAM Refresh Control Register
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
M6–M0
Reserved
Bits [15–9]—M6–M0 → Upper bits corresponding to address bits a19–a13 of the 20-bit
memory refresh address. These bits are not available on the a19–a0 bus. When using
PSRAM mode, M6–M0 must be programmed to 0000000b.
Bits [8–0]—Reserved → These bits read back as 0.
5.1.8 D1CON (0dah) and D0CON (0cah)
DMA CONtrol Registers. DMA Control Registers control operation of the two DMA channels.
The D0CON and D1CON registers are undefined at reset, except ST which is set to 0 (see
Table 24).
Table 24. DMA Control Registers
15
14 13 12
11 10 9 8 7
654 3 21 0
DM/IOn DDEC DINC SM/IOn SDEC SINC TC INT SYN1–SYN0 P TDRQ Res CHG ST Bn/W
Bit [15]—DM/IOn → Destination Address Space Select selects memory or I/O space for
the destination address. When DM/IO is set to 1, the destination address is in memory
space. When 0, it is in I/O space.
®
IA211050831-19
http://www.Innovasic.com
UNCONTROLLED WHEN PRINTED OR COPIED
Customer Support:
Page 62 of 146
1-888-824-4184