PIC17C7XX_13 Datasheet, PDF (53/306 Pages) Microchip Technology – High-Performance 8-bit CMOS EPROM Microcontrollers with 10-bit A/D

PIC17C7XX
7.2.2.3
TMR0 Status/Control Register
(T0STA)
This register contains various control bits. Bit7
(INTEDG) is used to control the edge upon which a sig-
nal on the RA0/INT pin will set the RA0/INT interrupt
flag. The other bits configure Timer0, it’s prescaler and
clock source.
REGISTER 7-3: T0STA REGISTER (ADDRESS: 05h, UNBANKED)
R/W-0
INTEDG
bit 7
R/W-0
T0SE
R/W-0
T0CS
R/W-0
T0PS3
R/W-0
T0PS2
R/W-0
T0PS1
R/W-0
T0PS0
U-0
—
bit 0
bit 7
bit 6
bit 5
bit 4-1
bit 0
INTEDG: RA0/INT Pin Interrupt Edge Select bit
This bit selects the edge upon which the interrupt is detected.
1 = Rising edge of RA0/INT pin generates interrupt
0 = Falling edge of RA0/INT pin generates interrupt
T0SE: Timer0 External Clock Input Edge Select bit
This bit selects the edge upon which TMR0 will increment.
When T0CS = 0 (External Clock):
1 = Rising edge of RA1/T0CKI pin increments TMR0 and/or sets the T0CKIF bit
0 = Falling edge of RA1/T0CKI pin increments TMR0 and/or sets a T0CKIF bit
When T0CS = 1 (Internal Clock):
Don’t care
T0CS: Timer0 Clock Source Select bit
This bit selects the clock source for Timer0.
1 = Internal instruction clock cycle (TCY)
0 = External clock input on the T0CKI pin
T0PS3:T0PS0: Timer0 Prescale Selection bits
These bits select the prescale value for Timer0.
T0PS3:T0PS0 Prescale Value
0000
0001
0010
0011
0100
0101
0110
0111
1xxx
1:1
1:2
1:4
1:8
1:16
1:32
1:64
1:128
1:256
Unimplemented: Read as '0'
Legend:
R = Readable bit
- n = Value at POR Reset
W = Writable bit
’1’ = Bit is set
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared x = Bit is unknown
 1998-2013 Microchip Technology Inc.
DS30289C-page 53