PIC17C7XX_13 Datasheet, PDF (195/306 Pages) Microchip Technology – High-Performance 8-bit CMOS EPROM Microcontrollers with 10-bit A/D

17.4.2 MINIMIZING CURRENT
CONSUMPTION
To minimize current consumption, all I/O pins should be
either at VDD, or VSS, with no external circuitry drawing
current from the I/O pin. I/O pins that are hi-impedance
inputs should be pulled high or low externally to avoid
switching currents caused by floating inputs. The
T0CKI input should be at VDD or VSS. The contributions
from on-chip pull-ups on PORTB should also be con-
sidered and disabled, when possible.
PIC17C7XX
17.5 Code Protection
The code in the program memory can be protected by
selecting the microcontroller in Code Protected mode
(PM2:PM0 = '000').
In this mode, instructions that are in the on-chip pro-
gram memory space, can continue to read or write the
program memory. An instruction that is executed out-
side of the internal program memory range will be
inhibited from writing to, or reading from, program
memory.
Note: Microchip does not recommend code pro-
tecting windowed devices.
If the code protection bit(s) have not been pro-
grammed, the on-chip program memory can be read
out for verification purposes.
 1998-2013 Microchip Technology Inc.
DS30289C-page 195