English
Language : 

PIC16F1847_13 Datasheet, PDF (163/440 Pages) Microchip Technology – 18/20/28-Pin Flash Microcontrollers with XLP Technology
19.0 COMPARATOR MODULE
Comparators are used to interface analog circuits to a
digital circuit by comparing two analog voltages and
providing a digital indication of their relative magnitudes.
Comparators are very useful mixed signal building
blocks because they provide analog functionality
independent of program execution. The analog
comparator module includes the following features:
• Independent comparator control
• Programmable input selection
• Comparator output is available internally/externally
• Programmable output polarity
• Interrupt-on-change
• Wake-up from Sleep
• Programmable Speed/Power optimization
• PWM shutdown
• Programmable and Fixed Voltage Reference
PIC16(L)F1847
19.1 Comparator Overview
A single comparator is shown in Figure 19-1 along with
the relationship between the analog input levels and
the digital output. When the analog voltage at VIN+ is
less than the analog voltage at VIN-, the output of the
comparator is a digital low level. When the analog
voltage at VIN+ is greater than the analog voltage at
VIN-, the output of the comparator is a digital high level.
FIGURE 19-1:
SINGLE COMPARATOR
VIN+
+
VIN-
–
Output
VIN-
VIN+
Output
Note:
The black areas of the output of the
comparator represents the uncertainty
due to input offsets and response time.
 2011-2013 Microchip Technology Inc.
Preliminary
DS40001453D-page 163