PIC16F1847_13 Datasheet, PDF (140/440 Pages) Microchip Technology – 18/20/28-Pin Flash Microcontrollers with XLP Technology

PIC16(L)F1847
16.1.5 INTERRUPTS
The ADC module allows for the ability to generate an
interrupt upon completion of an Analog-to-Digital
conversion. The ADC Interrupt Flag is the ADIF bit in
the PIR1 register. The ADC Interrupt Enable is the
ADIE bit in the PIE1 register. The ADIF bit must be
cleared in software.
Note 1: The ADIF bit is set at the completion of
every conversion, regardless of whether
or not the ADC interrupt is enabled.
2: The ADC operates during Sleep only
when the FRC oscillator is selected.
This interrupt can be generated while the device is
operating or while in Sleep. If the device is in Sleep, the
interrupt will wake-up the device. Upon waking from
Sleep, the next instruction following the SLEEP
instruction is always executed. If the user is attempting
to wake-up from Sleep and resume in-line code execu-
tion, the GIE and PEIE bits of the INTCON register
must be disabled. If the GIE and PEIE bits of the
INTCON register are enabled, execution will switch to
the Interrupt Service Routine.
Please refer to Section 16.1.5 “Interrupts” for more
information.
16.1.6 RESULT FORMATTING
The 10-bit ADC conversion result can be supplied in
two formats, left justified or right justified. The ADFM bit
of the ADCON1 register controls the output format.
Figure 16-3 shows the two output formats.
FIGURE 16-3:
10-BIT ADC CONVERSION RESULT FORMAT
ADRESH
(ADFM = 0) MSB
bit 7
bit 0
10-bit ADC Result
(ADFM = 1)
bit 7
MSB
bit 0
Unimplemented: Read as ‘0’
ADRESL
LSB
bit 7
bit 0
Unimplemented: Read as ‘0’
LSB
bit 7
bit 0
10-bit ADC Result
DS40001453D-page 140
Preliminary
 2011-2013 Microchip Technology Inc.