TC1163 Datasheet, PDF (94/134 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller TriCore

TC1163/TC1164
Preliminary
Electrical Parameters
1) Digital supply voltages applied to the TC1163/TC1164 must be static regulated voltages which allow a typical
voltage swing of ±5%.
2) Voltage overshoot up to 1.7 V is permissible at Power-Up and PORST low, provided the pulse duration is less
than 100 µs and the cumulated summary of the pulses does not exceed 1 h.
3) Voltage overshoot to 4 V is permissible at Power-Up and PORST low, provided the pulse duration is less than
100 µs and the cumulated summary of the pulses does not exceed 1 h.
4) The TC1163/TC1164 uses a static design, so the minimum operation frequency is 0 MHz. Due to test time
restriction no lower frequency boundary is tested, however.
5) The PLL jitter characteristics add to this value according to the application settings. See the PLL jitter
parameters.
6) Applicable for digital outputs.
7) See additional document “TC1796 Pin Reliability in Overload“ for overload current definitions.
Data Sheet
90
V1.0, 2008-04