MC68HC908QC16_07 Datasheet, PDF(39/274 Page) Freescale Semiconductor, Inc – Microcontrollers

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

MC68HC908QC16_07 Datasheet, PDF (39/274 Pages) Freescale Semiconductor, Inc – Microcontrollers

◁

FLASH Memory (FLASH)

2.6.4 FLASH Program Operation

Programming of the FLASH memory is done on a row basis. A row consists of 32 consecutive bytes

starting from addresses $XX00, $XX20, $XX40, $XX60, $XX80, $XXA0, $XXC0, or $XXE0. Use the

following step-by-step procedure to program a row of FLASH memory

Figure 2-4 shows a flowchart of the programming algorithm.

NOTE

Do not program any byte in the FLASH more than once after a successful

erase operation. Reprogramming bits to a byte which is already

programmed is not allowed without first erasing the page in which the byte

resides or mass erasing the entire FLASH memory. Programming without

first erasing may disturb data stored in the FLASH.

1. Set the PGM bit. This configures the memory for program operation and enables the latching of

address and data for programming.

2. Read the FLASH block protect register.

3. Write any data to any FLASH location within the address range desired.

4. Wait for a time, tNVS.

5. Set the HVEN bit.

6. Wait for a time, tPGS.

7. Write data to the FLASH address being programmed(1).

8. Wait for time, tPROG.

9. Repeat step 7 and 8 until all desired bytes within the row are programmed.

10. Clear the PGM bit (1).

11. Wait for time, tNVH.

12. Clear the HVEN bit.

13. After time, tRCV, the memory can be accessed in read mode again.

This program sequence is repeated throughout the memory until all data is programmed.

NOTE

Programming and erasing of FLASH locations cannot be performed by

code being executed from the FLASH memory. While these operations

must be performed in the order shown, other unrelated operations may

occur between the steps. Do not exceed tPROG maximum, see 19.17

Memory Characteristics.

1. The time between each FLASH address change, or the time between the last FLASH address programmed to clearing

PGM bit, must not exceed the maximum programming time, tPROG maximum.

MC68HC908QC16 â¢ MC68HC908QC8 â¢ MC68HC908QC4 Data Sheet, Rev. 3

Freescale Semiconductor

39

▷