MC68HC908QC16_07 Datasheet, PDF (136/274 Pages) Freescale Semiconductor, Inc – Microcontrollers

Enhanced Serial Communications Interface (ESCI) Module
13.7.2 ESCI Receive Data (RxD)
The RxD pin is the serial data input to the ESCI receiver. When the ESCI is enabled, the RxD pin becomes
an input.
13.8 Registers
The following registers control and monitor operation of the ESCI:
• ESCI control register 1, SCC1
• ESCI control register 2, SCC2
• ESCI control register 3, SCC3
• ESCI status register 1, SCS1
• ESCI status register 2, SCS2
• ESCI data register, SCDR
• ESCI baud rate register, SCBR
• ESCI prescaler register, SCPSC
• ESCI arbiter control register, SCIACTL
• ESCI arbiter data register, SCIADAT
13.8.1 ESCI Control Register 1
ESCI control register 1 (SCC1):
• Enables loop mode operation
• Enables the ESCI
• Controls output polarity
• Controls character length
• Controls ESCI wakeup method
• Controls idle character detection
• Enables parity function
• Controls parity type
Bit 7
6
5
4
3
2
1
Bit 0
Read:
LOOPS ENSCI TXINV
M
WAKE
ILTY
PEN
PTY
Write:
Reset: 0
0
0
0
0
0
0
0
Figure 13-9. ESCI Control Register 1 (SCC1)
LOOPS — Loop Mode Select Bit
This read/write bit enables loop mode operation. In loop mode the RxD pin is disconnected from the
ESCI, and the transmitter output goes into the receiver input. Both the transmitter and the receiver
must be enabled to use loop mode.
1 = Loop mode enabled
0 = Normal operation enabled
MC68HC908QC16 • MC68HC908QC8 • MC68HC908QC4 Data Sheet, Rev. 3
136
Freescale Semiconductor