TLK111_14 Datasheet, PDF (55/110 Pages) Texas Instruments – PHYTER® Industrial Temperature 10/100Mbs Ethernet Physical Layer Transceiver

TLK111
www.ti.com
SLLSEF8B – AUGUST 2013 – REVISED JANUARY 2014
8.1.6 Auto-Negotiation Link Partner Ability Register (ANLPAR) (BASE Page)
This register contains the advertised abilities of the Link Partner as received during Auto-Negotiation. The
content changes after the successful auto-negotiation if Next-pages are supported.
Table 8-9. Auto-Negotiation Link Partner Ability Register (ANLPAR) (BASE Page), address 0x0005
BIT BIT NAME
15 NP
14 ACK
13 RF
12 RESERVED
11 ASM_DIR
10 PAUSE
9 100B-T4
8 100B-TX_FD
7 100B-TX
6 10B-T_FD
5 10B-T
4:0 Selector
DEFAULT
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0 0000, RO
DESCRIPTION
Next Page Indication:
0 = Link Partner does not desire Next Page Transfer
1 = Link Partner desires Next Page Transfer
Acknowledge:
1 = Link Partner acknowledges reception of the ability data word
0 = Not acknowledged. The Auto-Negotiation state machine will automatically control the this bit
based on the incoming FLP bursts.
Remote Fault:
1 = Remote Fault indicated by Link Partner
0 = No Remote Fault indicated by Link Partner
RESERVED for Future IEEE use: Write as 0, read as 0
ASYMMETRIC PAUSE:
1 = Asymmetric pause is supported by the Link Partner
0 = Asymmetric pause is not supported by the Link Partner
PAUSE:
1 = Pause function is supported by the Link Partner
0 = Pause function is not supported by the Link Partner
100Base-T4 Support:
1 = 100Base-T4 is supported by the Link Partner
0 = 100Base-T4 is not supported by the Link Partner
100Base-TX Full Duplex Support:
1 = 100Base-TX Full Duplex is supported by the Link Partner
0 = 100Base-TX Full Duplex is not supported by the Link Partner
100Base-TX Support:
1 = 100Base-TX is supported by the Link Partner
0 = 100Base-TX is not supported by the Link Partner
10Base-T Full Duplex Support:
1 = 10Base-T Full Duplex is supported by the Link Partner
0 = 10Base-T Full Duplex is not supported by the Link Partner
10Base-T Support:
1 = 10Base-T is supported by the Link Partner
0 = 10Base-T is not supported by the Link Partner
Protocol Selection Bits:
Link Partner’s binary encoded protocol selector.
Copyright © 2013–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TLK111
Register Block
55