C8051F388-B Datasheet, PDF (219/285 Pages) Silicon Laboratories – Flash MCU Family

C8051F388/9/A/B
SFR Definition 24.2. SPI0CN: SPI0 Control
Bit
7
6
5
4
3
2
1
0
Name SPIF
WCOL MODF RXOVRN
NSSMD[1:0]
TXBMT SPIEN
Type R/W
R/W
R/W
R/W
R/W
R
R/W
Reset
0
0
0
0
0
1
1
0
SFR Address = 0xF8; SFR Page = All Pages; Bit-Addressable
Bit
Name
Function
7
SPIF
SPI0 Interrupt Flag.
This bit is set to logic 1 by hardware at the end of a data transfer. If SPI interrupts
are enabled, an interrupt will be generated. This bit is not automatically cleared by
hardware, and must be cleared by software.
6
WCOL Write Collision Flag.
This bit is set to logic 1 if a write to SPI0DAT is attempted when TXBMT is 0. When
this occurs, the write to SPI0DAT will be ignored, and the transmit buffer will not be
written. If SPI interrupts are enabled, an interrupt will be generated. This bit is not
automatically cleared by hardware, and must be cleared by software.
5
MODF Mode Fault Flag.
This bit is set to logic 1 by hardware when a master mode collision is detected
(NSS is low, MSTEN = 1, and NSSMD[1:0] = 01). If SPI interrupts are enabled, an
interrupt will be generated. This bit is not automatically cleared by hardware, and
must be cleared by software.
4 RXOVRN Receive Overrun Flag (valid in slave mode only).
This bit is set to logic 1 by hardware when the receive buffer still holds unread data
from a previous transfer and the last bit of the current transfer is shifted into the
SPI0 shift register. If SPI interrupts are enabled, an interrupt will be generated. This
bit is not automatically cleared by hardware, and must be cleared by software.
3:2 NSSMD[1:0] Slave Select Mode.
Selects between the following NSS operation modes:
(See Section 24.2 and Section 24.3).
00: 3-Wire Slave or 3-Wire Master Mode. NSS signal is not routed to a port pin.
01: 4-Wire Slave or Multi-Master Mode (Default). NSS is an input to the device.
1x: 4-Wire Single-Master Mode. NSS signal is mapped as an output from the
device and will assume the value of NSSMD0.
1
TXBMT Transmit Buffer Empty.
This bit will be set to logic 0 when new data has been written to the transmit buffer.
When data in the transmit buffer is transferred to the SPI shift register, this bit will
be set to logic 1, indicating that it is safe to write a new byte to the transmit buffer.
0
SPIEN SPI0 Enable.
0: SPI disabled.
1: SPI enabled.
Rev. 1.1
219