PIC18F2480_09 Datasheet, PDF (59/490 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology

PIC18F2480/2580/4480/4580
TABLE 5-4: INITIALIZATION CONDITIONS FOR ALL REGISTERS (CONTINUED)
Register
Applicable Devices
Power-on Reset,
Brown-out Reset
MCLR Resets,
WDT Reset,
RESET Instruction,
Stack Resets
Wake-up via WDT
or Interrupt
BRGCON3 2480 2580 4480 4580 00-- -000
00-- -000
uu-- -uuu
BRGCON2 2480 2580 4480 4580 0000 0000
0000 0000
uuuu uuuu
BRGCON1 2480 2580 4480 4580 0000 0000
0000 0000
uuuu uuuu
CANCON
2480 2580 4480 4580 1000 000-
1000 000-
uuuu uuu-
CANSTAT
2480 2580 4480 4580 100- 000-
100- 000-
uuu- uuu-
RXB0D7
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D6
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D5
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D4
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D3
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D2
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D1
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0D0
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0DLC
2480 2580 4480 4580 -xxx xxxx
-uuu uuuu
-uuu uuuu
RXB0EIDL 2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0EIDH 2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0SIDL 2480 2580 4480 4580 xxxx x-xx
uuuu u-uu
uuuu u-uu
RXB0SIDH 2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB0CON 2480 2580 4480 4580 000- 0000
000- 0000
uuu- uuuu
RXB1D7
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D6
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D5
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D4
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D3
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D2
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D1
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1D0
2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1DLC
2480 2580 4480 4580 -xxx xxxx
-uuu uuuu
-uuu uuuu
RXB1EIDL 2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1EIDH 2480 2580 4480 4580 xxxx xxxx
uuuu uuuu
uuuu uuuu
RXB1SIDL 2480 2580 4480 4580 xxxx x-xx
uuuu u-uu
uuuu u-uu
Legend: u = unchanged, x = unknown, - = unimplemented bit, read as ‘0’, q = value depends on condition.
Shaded cells indicate conditions do not apply for the designated device.
Note 1: One or more bits in the INTCONx or PIRx registers will be affected (to cause wake-up).
2: When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the PC is loaded with the interrupt
vector (0008h or 0018h).
3: When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the TOSU, TOSH and TOSL are
updated with the current value of the PC. The STKPTR is modified to point to the next location in the
hardware stack.
4: See Table 5-3 for Reset value for specific condition.
5: Bits 6 and 7 of PORTA, LATA and TRISA are enabled, depending on the oscillator mode selected. When
not enabled as PORTA pins, they are disabled and read ‘0’.
6: This register reads all ‘0’s until ECAN™ technology is set up in Mode 1 or Mode 2.
© 2009 Microchip Technology Inc.
DS39637D-page 59