PIC18F2480_09 Datasheet, PDF (320/490 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology

PIC18F2480/2580/4480/4580
24.2.5 CAN MODULE I/O CONTROL
REGISTER
This register controls the operation of the CAN module’s
I/O pins in relation to the rest of the microcontroller.
REGISTER 24-55: CIOCON: CAN I/O CONTROL REGISTER
U-0
U-0
R/W-0
R/W-0
U-0
U-0
—
—
ENDRHI⁽¹⁾ CANCAP
—
—
bit 7
U-0
U-0
—
—
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-6
bit 5
bit 4
bit 3-0
Unimplemented: Read as ‘0’
ENDRHI: Enable Drive High bit⁽¹⁾
1 = CANTX pin will drive VDD when recessive
0 = CANTX pin will be tri-state when recessive
CANCAP: CAN Message Receive Capture Enable bit
1 = Enable CAN capture, CAN message receive signal replaces input on RC2/CCP1
0 = Disable CAN capture, RC2/CCP1 input to CCP1 module
Unimplemented: Read as ‘0’
Note 1: Always set this bit when using a differential bus to avoid signal crosstalk in CANTX from other nearby pins.
DS39637D-page 320
© 2009 Microchip Technology Inc.