HD6475368CP Datasheet, PDF (94/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Using the Reader The command name for the HP 64000 Reader is RHP64000.EXE. To
from MS-DOS ^{execute the Reader from the command line, for example, enter:}
RHP64000 [-q] <filename>
-q
This option specifies the “quiet” mode, and
suppresses the display of messages.
<filename>
This represents the name of the HP 64000 linker
symbol file (file.L) for the absolute file to be loaded.
The following command will create the files “TESTPROG.HPA” and
“TESTPROG.HPS”
RHP64000 TESTPROG.L
Using the Reader
from the PC Interface
The PC Interface has a file format option under the “Memory Load”
command. After you select HP64000 as the file format, the HP 64000
Reader will operate on the file you specify. After this completes
successfully, the PC Interface will accept the absolute and symbol files
produced by the Reader.
To use the Reader from the PC Interface:
1. Start up the PC Interface.
2. Select “Memory Load.” The memory load menu will appear.
3. Specify the file format as “HP64000.” This will appear as the
default file format.
4. Specify the name of an HP 64000 linker symbol file
(TESTFILE.L for example).
Using the HP 64000 file that you specify (TESTFILE.L, for example),
the PC Interface performs the following:
It checks to see if two files with the same base name and
extensions .HPS and .HPA already exist (for example,
TESTFILE.HPS and TESTFILE.HPA).
A-4 File Format Readers