HD6475368CP Datasheet, PDF (54/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

System, Log, Input, Disable
The command file cmd_rds.cmd will no longer accept command input.
Let’s execute the command file "cmd_rds.cmd".
System, Command_file
Enter "cmd_rds.cmd", press Enter. As you can see, the sequence of
commands you entered is automatically executed.
Resetting the
Emulator
To reset the emulator, select:
Processor, Reset, Hold
The emulator is held in a reset state (suspended) until a "Processor
Break", "Processor Go", or "Processor Step" command is entered. A
CMB execute signal will also cause the emulator to run if reset.
You can also specify that the emulator begin executing in the monitor
after reset instead of remaining in the suspended state. To do this,
select:
Processor, Reset, Monitor
2-56 Getting Started