HD6475368CP Datasheet, PDF (46/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Run the program by selecting:
Processor, Go, Pc
The status line shows that the emulator is running the user program.
Modify the command input byte to an invalid command by selecting:
Memory, Modify, Bytes
Enter an invalid command, such as "Cmd_Input=75". The following
messages result:
ALERT: Software breakpoint: 001029
STATUS: H8/536--Running in monitor
To continue program execution, select:
Processor, Go, Pc
Displaying Software To view the status of the breakpoint, select:
Breakpoints
Breakpoints, Display
The resulting display will show that the breakpoint has been cleared.
Setting a Software When a breakpoint is hit, it becomes disabled. To re-enable the
Breakpoint ^{software breakpoint, you can select:}
Breakpoints, Set, Single
The address of the breakpoint you just added is still in the address
field; to set this breakpoint again, press Enter. As with the
"Breakpoints Add"command, the breakpoint window becomes active
and shows that the breakpoint is set.
Clearing a Software If you wish to clear a software breakpoint that does not get hit during
Breakpoint ^{program execution, you can select:}
Breakpoints, Clear, Single
The address of the breakpoint set in the previous section is still in the
address field; to clear this breakpoint again, press Enter.
2-48 Getting Started