HD6475368CP Datasheet, PDF (60/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Note
To make sure the contact between emulator probe and target system
microprocessor socket, we recommend that you use
ITT CANNON "LCS-84" series 84 pin PLCC socket.
Running the
Emulator from
Target Reset
You can specify that the emulator begins executing from target system
reset. When the target system /RES line becomes active and then
inactive, the emulator will start reset sequence (operation) as actual
microprocessor.
At First, you must specify the emulator responds to /RES signal by the
target system (see the "Enable /RES input from Target" configuration
in Chapter 4 of this manual).
To specify a run from reset state, select:
Processor, Go, Reset
The status now shows that the emulator is "Awaiting target reset".
After the target system is reset, the status line message will change to
show the appropriate emulator status.
3-62 In-Circuit Emulation