HD6475368CP Datasheet, PDF (30/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

*** LINKAGE EDITOR LINK MAP LIST ***
SECTION
NAME
START
-
END
UNIT NAME
LENGTH
MODULE NAME
ATTRIBUTE : CODE NOSHR
Prog
* TOTAL ADDRESS *
H’0000:1000 - H’0000:1042
cmd_rds
H’0000:1000 - H’0000:1042
H’00000043
cmd_rds
H’00000043
ATTRIBUTE : DATA NOSHR
Table
* TOTAL ADDRESS *
H’0000:1100 - H’0000:1133
cmd_rds
H’0000:1100 - H’0000:1133
H’00000034
cmd_rds
H’00000034
ATTRIBUTE : DATA SHR
Data
* TOTAL ADDRESS *
H’0000:FC00 - H’0000:FC7F
cmd_rds
H’0000:FC00 - H’0000:FC7F
H’00000080
cmd_rds
H’00000080
Figure 2-4. Sample Program Load Map Listing
From the load map listing, you can see that the sample program
occupies locations in three address ranges. The code area, which
contains the opcodes and operands which make up the sample program,
occupies locations 1000 hex through 1042 hex. The data area, which
contains the ASCII values of the messages the program displays, is
occupies locations 1100 hex through 1133 hex. The destination area,
which contains the command input byte and the locations of the
message destination and the stack, occupies locations FC00 hex
through FC7F hex.
Two mapper terms will be specified for the example program. Since
the program writes to the destination locations, the mapper block
containing the destination locations should not be characterized as
ROM memory.
To map memory for the sample program, select:
Config, Map, Modify
2-32 Getting Started