HD6475368CP Datasheet, PDF (63/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Internal Emulator
Clock?
This configuration question allows you to select the emulator’s clock
source; you can choose either the internal clock source or the target
system clock source. The default emulator configuration selects the
internal clock.
yes
Selects the internal clock oscillator as the emulator
clock source. The emulators’ internal clock speed
is 10 MHz (system clock).
no
Selects the clock input to the emulator probe from
the target system. You must use a clock input
conforming to the specifications for the H8/536
microprocessor.
You should always select the external clock option when using the
emulator in-circuit to ensure that the emulator is properly synchronized
with your target system.
Note
Changing the clock source drives the emulator into the reset state.
Enable Real-Time
Mode?
If it is important that the emulator execute target system programs in
real-time, you can enable the real-time emulator mode. In other words,
when you execute target programs (with the "Processor, Go"
command), the emulator will execute in real-time.
Configuring the Emulator 4-3