HD6475368CP Datasheet, PDF (75/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Note
To use the foreground monitor, follow below steps.
1. Decide which location the foreground monitor should be
loaded.
2. Assemble and link the foreground monitor program along with
the location you decided.
3. Configure the emulator as described in this chapter. (monitor
type selection and monitor location).
4. Load the foreground monitor program into memory by
"Memory Load" feature.
Changing this configuration drives the emulator into the reset state.
Foreground
Monitor Address
You must specify foreground monitor start address when you select
"fg" by above configuration question "Monitor type". This address
specification must be same with the address specification when you
assemble the foreground monitor program.
The address must be specified in a 20-bit hexadecimal address, and
must be located on a 2K byte boundary other than 0 hex.
Configuring the Emulator 4-15