HD6475368CP Datasheet, PDF (53/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

The resulting display shows the Cmd_B instructions and the branch to
Write_Msg and the beginning of the instructions which move the
"THIS IS MESSAGE B" message to the destination locations.
For a Complete
Description
For a complete description of using the HP 64700 Series analyzer with
the PC Interface, refer to the HP 64700 Emulators PC Interface:
Analyzer User’s Guide.
Using a Command
File
You can use a command file to perform many functions for you,
without having to manually type each function. For example, you
might want to create a command file that modifies configuration, maps
memory and loads program into memory for the sample program. To
create such a command file:
System, Log, Input, Enable
Enter command file name "cmd_rds.cmd", and press Enter. This sets
up a file to record all commands you execute. The commands will be
logged to the file cmd_rds.cmd in the current directory. You can then
use this file as a command file to execute these commands
automatically.
First, to set up the reset value for the stack pointer:
Config, General
Use the arrow keys to move the cursor to the "Reset value for Stack
Pointer" field, type 0fc80, and press End and Enter.
To map the memory:
Config, Map, Memory
Map 1000 hex through 1fff hex to erom and fc00 hex through fcff hex
to eram. (As shown in Figure 2-5.)
To load the program into memory:
Memory, Load
Enter file format, memory type, and absolute file name, and press
Enter.
Now we’re finished logging commands to the file. To disable logging:
Getting Started 2-55