HD6475368CP Datasheet, PDF (40/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Note
You cannot display registers if the processor is reset. Use the
"Processor Break" command to cause the emulator to start executing in
the monitor.
You can display registers while the emulator is executing a user
program (if execution is not restricted to real-time); emulator execution
will temporarily break to the monitor.
To continue stepping through the program, you can select:
Processor, Step, Pc
After selecting the command above, you have an opportunity to change
the previous step count. If you wish to step the same number of times,
you can press Enter to start the step.
To save time when single-stepping, you can use the function key macro
<F1>, which executes the command,
Processor, Step, Pc, 1
For more information, see the Emulator PC Interface Reference
manual.
To repeat the previous command, you can press <CTRL>r.
Specifying a Step If you wish to continue to step a number of times from the current
Count ^{program counter, select:}
Processor, Step, Pc
The previous step count is displayed in the "number of instructions"
field. You can enter a number from 1 through 99 to specify the number
of times to step. Type 5 into the field, and press Enter. The resulting
display follows.
2-42 Getting Started