HD6475368CP Datasheet, PDF (61/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

4
Configuring the Emulator
Introduction
The H8/536 emulator can be used in all stages of target system
development. For instance, you can run the emulator out-of-circuit
when developing target system software, or you can use the emulator
in-circuit when integrating software with target system hardware.
Emulation memory can be used in place of, or along with, target
system memory. You can use the emulator’s internal clock or the
target system clock. You can execute target programs in real-time or
allow emulator execution to be diverted into the monitor when
commands request access of target system resources (target system
memory, register contents, etc.)
The emulator is a flexible instrument and it may be configured to suit
your needs at any stage of the development process. This chapter
describes the options available when configuring the H8/536 emulator.
This chapter will:
Show you how to access the emulator configuration options.
Describe the emulator configuration options.
Show you how to save a particular emulator configuration,
and load it again at a later time.
Configuring the Emulator 4-1