HD6475368CP Datasheet, PDF (28/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Selecting PC
Interface Commands
This manual will tell you to "select" commands. You can select
commands or command options by either using the left and right arrow
keys to highlight the option and press the Enter key, or you can simply
type the first letter of that option. If you select the wrong option, you
can press the ESC key to move back up the command tree.
When a command or command option is highlighted, a short message
describing that option is shown on the bottom line of the display.
Emulator Status
The status of the emulator is shown on the line above the command
options. The PC Interface periodically checks the status of the
emulator and updates the status line.
Modifying
Configuration
You need to set up the emulation configuration before using the sample
program. To access the emulation configuration display, enter:
Config, General
Defining the Reset
Value for the Stack
Pointer
Even though the H8/536 emulator has a background monitor, it
requires you to define a stack pointer.
Use the arrow keys to move the cursorto the "Reset value for Stack
Pointer" field, type 0fc80 and press Enter.
The stack pointer value will be set to the stack pointer (SP) on entrance
to the emulation monitor initiated RESET state (the "Emulation reset"
status).
Selecting your
Processor
You need to select the processor you are going to emulate. Use the
arrow keys to move the cursor to the "Processor type?" field. Use the
TAB key to select the processor you are going to emulate.
2-30 Getting Started