HD6475368CP Datasheet, PDF (51/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Starting the Trace To start the trace, select:
Analysis, Begin
A message on the status line will show you that the trace is running.
You do not expect the trigger to be found because no commands have
been entered. Modify the command input byte to "B" by selecting:
Memory, Modify, Byte
Enter "Cmd_Input=42". The status line now shows that the trace is
complete.
Displaying the Trace To display the trace, select:
Analysis, Display
You are now given two fields in which to specify the states to display.
Use the right arrow key to move the cursor to the "Ending state to
display" field. Type "60" into the ending state field, press Enter, and
use <CTRL>z to zoom the trace window.
Note
If you choose to dump a complete trace into the trace buffer, it will
take a few minutes to display the trace.
Use the Home key to get the top of the trace. The resulting trace is
similar to the trace shown in the following display.
Getting Started 2-53