HD6475368CP Datasheet, PDF (76/108 Pages) Agilent(Hewlett-Packard) – H8/536 Emulator PC Interface

Reset Value for
Stack Pointer?
Note
This question allows you to specify the value to which the stack pointer
(SP) and the stack page register (TP) will be set on entrance to the
emulation monitor initiated RESET state (the "Emulation reset" status).
The address specified in response to this question must be a 20-bit
hexadecimal even address.
You cannot set this address at the following location.
Odd address
Internal I/O register address
When you are using the foreground monitor, this address should be
defined in an emulation or target system RAM area which is not used
by user program.
We recommend that you use this method of configuring the stack
pointer and the stack page register. Without a stack pointer and a stack
page register, the emulator is unable to make the transition to the run
state, step, or perform many other emulation functions. However,
using this option does not preclude you from changing the stack
pointer value or location within your program; it just sets the initial
conditions to allow a run to begin.
4-16 Configuring the Emulator