HD6475328-CP10 Datasheet, PDF (210/459 Pages) Hitachi Semiconductor – original Hitachi CMOS microcomputer unit (MCU)

FRC Clear Timing: If the CCLRA bit is set to “1,” the FRC is cleared when compare-match A
occurs. Figure 10-6 shows the timing of this operation.
ø
Internal compare-
match A signal
FRC
N
H’0000
Figure 10-6 Clearing of FRC by Compare-Match A
10.4.3 Input Capture Timing
1. Input Capture Timing: An internal input capture signal is generated from the rising or falling
edge of the input at the input capture pin (FTI), as selected by the IEDG bit in the TCSR.
Figure 10-7 shows the usual input capture timing when the rising edge is selected
(IEDG = “1”).
ø
Input at FTI pin
Internal input
capture signal
Figure 10-7 Input Capture Timing (Usual Case)
But if the upper byte of the ICR is being read when the input capture signal arrives, the internal
input capture signal is delayed by one state. Figure 10-8 shows the timing for this case.
193