MC9S12C Datasheet, PDF (591/680 Pages) Motorola, Inc – 16-Bit Microcontroller

Chapter 20 96 Kbyte Flash Module (S12FTS96KV1)
20.4.1.3.1 Erase Verify Command
The erase verify operation will verify that a Flash array is erased.
An example flow to execute the erase verify operation is shown in Figure 20-22. The erase verify command
write sequence is as follows:
1. Write to a Flash array address to start the command write sequence for the erase verify command.
The address and data written will be ignored.
2. Write the erase verify command, 0x05, to the FCMD register.
3. Clear the CBEIF flag in the FSTAT register by writing a 1 to CBEIF to launch the erase verify
command.
After launching the erase verify command, the CCIF flag in the FSTAT register will set after the operation
has completed unless a new command write sequence has been buffered. Upon completion of the erase
verify operation, the BLANK flag in the FSTAT register will be set if all addresses in the Flash array are
verified to be erased. If any address in the Flash array is not erased, the erase verify operation will terminate
and the BLANK flag in the FSTAT register will remain clear.
Freescale Semiconductor
MC9S12C-Family / MC9S12GC-Family
591
Rev 01.23