SI5341 Datasheet, PDF (52/56 Pages) Silicon Laboratories – LOW-JITTER, 10-OUTPUT, ANY-FREQUENCY, ANY-OUTPUT CLOCK GENERATOR

Si5341/40
Table 21. PCB Land Pattern Dimensions
Dimension
C1
Si5341 (Max)
8.90
Si5340 (Max)
6.90
C2
8.90
6.90
E
0.50
0.50
X1
0.30
0.30
Y1
0.85
0.85
X2
5.30
5.30
Y2
5.30
5.30
Notes:
General
1. All dimensions shown are in millimeters (mm) unless otherwise noted.
2. This Land Pattern Design is based on the IPC-7351 guidelines.
3. All dimensions shown are at Maximum Material Condition (MMC). Least
Material Condition is calculated based on a fabrication Allowance of 0.05 mm.
Solder Mask Design
4. All metal pads are to be non-solder mask defined (NSMD). Clearance
between the solder mask and the metal pad is to be 60 µm minimum, all the
way around the pad.
Stencil Design
5. A stainless steel, laser-cut and electro-polished stencil with trapezoidal walls
should be used to assure good solder paste release.
6. The stencil thickness should be 0.125 mm (5 mils).
7. The ratio of stencil aperture to land pad size should be 1:1 for all perimeter
pads.
8. A 3x3 array of 1.25 mm square openings on 1.80 mm pitch should be used for
the center ground pad.
Card Assembly
9. A No-Clean, Type-3 solder paste is recommended.
10. The recommended card reflow profile is per the JEDEC/IPC J-STD-020
specification for Small Body Components.
52
Rev. 1.0