C8051F388 Datasheet, PDF (274/285 Pages) –

C8051F388/9/A/B
SFR Definition 26.3. PCA0CPMn: PCA Capture/Compare Mode
Bit
7
6
5
4
3
2
1
0
Name PWM16n ECOMn CAPPn CAPNn MATn
TOGn PWMn ECCFn
Type R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset
0
0
0
0
0
0
0
0
SFR Addresses: 0xDA (n = 0), 0xDB (n = 1), 0xDC (n = 2), 0xDD (n = 3), 0xDE (n = 4)
SFR Pages: All Pages (n = 0), All Pages (n = 1), All Pages (n = 2), All Pages (n = 3), All Pages (n = 4)
Bit Name
Function
7 PWM16n 16-bit Pulse Width Modulation Enable.
This bit enables 16-bit mode when Pulse Width Modulation mode is enabled.
0: 8-bit PWM selected.
1: 16-bit PWM selected.
6 ECOMn Comparator Function Enable.
This bit enables the comparator function for PCA module n when set to 1.
5 CAPPn Capture Positive Function Enable.
This bit enables the positive edge capture for PCA module n when set to 1.
4 CAPNn Capture Negative Function Enable.
This bit enables the negative edge capture for PCA module n when set to 1.
3 MATn Match Function Enable.
This bit enables the match function for PCA module n when set to 1. When enabled,
matches of the PCA counter with a module's capture/compare register cause the CCFn
bit in PCA0MD register to be set to logic 1.
2 TOGn Toggle Function Enable.
This bit enables the toggle function for PCA module n when set to 1. When enabled,
matches of the PCA counter with a module's capture/compare register cause the logic
level on the CEXn pin to toggle. If the PWMn bit is also set to logic 1, the module oper-
ates in Frequency Output Mode.
1 PWMn Pulse Width Modulation Mode Enable.
This bit enables the PWM function for PCA module n when set to 1. When enabled, a
pulse width modulated signal is output on the CEXn pin. 8-bit PWM is used if PWM16n
is cleared; 16-bit mode is used if PWM16n is set to logic 1. If the TOGn bit is also set,
the module operates in Frequency Output Mode.
0 ECCFn Capture/Compare Flag Interrupt Enable.
This bit sets the masking of the Capture/Compare Flag (CCFn) interrupt.
0: Disable CCFn interrupts.
1: Enable a Capture/Compare Flag interrupt request when CCFn is set.
Note: When the WDTE bit is set to 1, the PCA0CPM4 register cannot be modified, and module 4 acts as the
watchdog timer. To change the contents of the PCA0CPM4 register or the function of module 4, the Watchdog
Timer must be disabled.
274
Rev. 1.1