C8051F336_08 Datasheet, PDF (205/227 Pages) Silicon Laboratories – Mixed-Signal Byte-Programmable EPROM MCU

C8051F336/7/8/9
25.3. Capture/Compare Modules
Each module can be configured to operate independently in one of six operation modes: edge-triggered
capture, software timer, high-speed output, frequency output, 8 to 11-bit pulse width modulator, or 16-bit
pulse width modulator. Each module has Special Function Registers (SFRs) associated with it in the CIP-
51 system controller. These registers are used to exchange data with a module and configure the module's
mode of operation. Table 25.2 summarizes the bit settings in the PCA0CPMn and PCA0PWM registers
used to select the PCA capture/compare module’s operating mode. Note that all modules set to use 8, 9,
10, or 11-bit PWM mode must use the same cycle length (8–11 bits). Setting the ECCFn bit in a
PCA0CPMn register enables the module's CCFn interrupt.
Table 25.2. PCA0CPM and PCA0PWM Bit Settings for PCA Capture/Compare
Modules
Operational Mode
PCA0CPMn
PCA0PWM
Bit Number 7 6 5 4 3 2 1 0 7 6 5 4–2 1–0
Capture triggered by positive edge on CEXn
X X 1 0 0 0 0 A 0 X B XXX XX
Capture triggered by negative edge on CEXn
X X 0 1 0 0 0 A 0 X B XXX XX
Capture triggered by any transition on CEXn
X X 1 1 0 0 0 A 0 X B XXX XX
Software Timer
X C 0 0 1 0 0 A 0 X B XXX XX
High Speed Output
X C 0 0 1 1 0 A 0 X B XXX XX
Frequency Output
X C 0 0 0 1 1 A 0 X B XXX XX
8-Bit Pulse Width Modulator (Note 7)
0 C 0 0 E 0 1 A 0 X B XXX 00
9-Bit Pulse Width Modulator (Note 7)
0 C 0 0 E 0 1 A D X B XXX 01
10-Bit Pulse Width Modulator (Note 7)
0 C 0 0 E 0 1 A D X B XXX 10
11-Bit Pulse Width Modulator (Note 7)
0 C 0 0 E 0 1 A D X B XXX 11
16-Bit Pulse Width Modulator
1 C 0 0 E 0 1 A 0 X B XXX XX
Notes:
1. X = Don’t Care (no functional difference for individual module if 1 or 0).
2. A = Enable interrupts for this module (PCA interrupt triggered on CCFn set to 1).
3. B = Enable 8th, 9th, 10th or 11th bit overflow interrupt (Depends on setting of CLSEL[1:0]).
4. C = When set to 0, the digital comparator is off. For high speed and frequency output modes, the
associated pin will not toggle. In any of the PWM modes, this generates a 0% duty cycle (output = 0).
5. D = Selects whether the Capture/Compare register (0) or the Auto-Reload register (1) for the associated
channel is accessed via addresses PCA0CPHn and PCA0CPLn.
6. E = When set, a match event will cause the CCFn flag for the associated channel to be set.
7. All modules set to 8, 9, 10 or 11-bit PWM mode use the same cycle length setting.
Rev.1.0
205