C8051F336_08 Datasheet, PDF (148/227 Pages) Silicon Laboratories – Mixed-Signal Byte-Programmable EPROM MCU

C8051F336/7/8/9
of the slave address mask means that bit will be treated as a “don’t care” for comparison purposes. In this
case, either a 1 or a 0 value are acceptable on the incoming slave address. Additionally, if the GC bit in
register SMB0ADR is set to 1, hardware will recognize the General Call Address (0x00). Table 21.4 shows
some example parameter settings and the slave addresses that will be recognized by hardware under
those conditions.
Table 21.4. Hardware Address Recognition Examples (EHACK = 1)
Hardware Slave Address
SLV[6:0]
0x34
0x34
0x34
0x34
0x70
Slave Address Mask
SLVM[6:0]
0x7F
0x7F
0x7E
0x7E
0x73
GC bit
0
1
0
1
0
Slave Addresses Recognized by
Hardware
0x34
0x34, 0x00 (General Call)
0x34, 0x35
0x34, 0x35, 0x00 (General Call)
0x70, 0x74, 0x78, 0x7C
SFR Definition 21.3. SMB0ADR: SMBus Slave Address
Bit
7
6
5
4
3
2
1
0
Name
SLV[6:0]
GC
Type
R/W
R/W
Reset
0
0
0
0
0
0
0
0
SFR Address = 0xD7
Bit
Name
7:1 SLV[6:0]
0
GC
Function
SMBus Hardware Slave Address.
Defines the SMBus Slave Address(es) for automatic hardware acknowledgement.
Only address bits which have a 1 in the corresponding bit position in SLVM[6:0]
are checked against the incoming address. This allows multiple addresses to be
recognized.
General Call Address Enable.
When hardware address recognition is enabled (EHACK = 1), this bit will deter-
mine whether the General Call Address (0x00) is also recognized by hardware.
0: General Call Address is ignored.
1: General Call Address is recognized.
148
Rev.1.0