C8051F336_08 Datasheet, PDF (15/227 Pages) Silicon Laboratories – Mixed-Signal Byte-Programmable EPROM MCU

C8051F336/7/8/9
1. System Overview
C8051F336/7/8/9 devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features
are listed below. Refer to Section “2. Ordering Information” on page 18 for specific product feature
selection and part ordering numbers.
High-speed pipelined 8051-compatible microcontroller core (up to 25 MIPS)
In-system, full-speed, non-intrusive debug interface (on-chip)
True 10-bit 200 ksps 20-channel single-ended/differential ADC with analog multiplexer
10-bit Current Output DAC
Precision programmable 24.5 MHz internal oscillator
Low-power, low-frequency oscillator
16 kB of on-chip Flash memory—512 bytes are reserved
768 bytes of on-chip RAM
SMBus/I2C, Enhanced UART, and Enhanced SPI serial interfaces implemented in hardware
Four general-purpose 16-bit timers
Programmable Counter/Timer Array (PCA) with three capture/compare modules and Watchdog Timer
function
On-chip Power-On Reset, V_DD Monitor, and Temperature Sensor
On-chip Voltage Comparator
21 or 17 Port I/O (5 V tolerant)
Low-power suspend mode with fast wake-up time
With on-chip Power-On Reset, V_DD monitor, Watchdog Timer, and clock oscillator, the C8051F336/7/8/9
devices are truly stand-alone System-on-a-Chip solutions. The Flash memory can be reprogrammed even
in-circuit, providing non-volatile data storage, and also allowing field upgrades of the 8051 firmware. User
software has complete control of all peripherals, and may individually shut down any or all peripherals for
power savings.
The on-chip Silicon Labs 2-Wire (C2) Development Interface allows non-intrusive (uses no on-chip
resources), full speed, in-circuit debugging using the production MCU installed in the final application. This
debug logic supports inspection and modification of memory and registers, setting breakpoints, single
stepping, run and halt commands. All analog and digital peripherals are fully functional while debugging
using C2. The two C2 interface pins can be shared with user functions, allowing in-system debugging with-
out occupying package pins.
Each device is specified for 2.7 to 3.6 V operation over the industrial temperature range (–40 to +85 °C).
The Port I/O and RST pins are tolerant of input signals up to 5 V. The C8051F336/7 are available in a 20-
pin QFN package and the C8051F338/9 are available in a 24-pin QFN package. Both package options are
lead-free and RoHS compliant. See Section “2. Ordering Information” on page 18 for ordering informa-
tion. Block diagrams are included in Figure 1.1 and Figure 1.2.
Rev.1.0
15