4509 Datasheet, PDF (23/142 Pages) Renesas Technology Corp – SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER

4509 Group
EXTERNAL INTERRUPTS
The 4509 Group has the external 0 interrupt. An external interrupt
request occurs when a valid waveform is input to an interrupt input
pin (edge detection).
The external interrupt can be controlled with the interrupt control
register I1.
Table 7 External interrupt activated conditions
Name
Input pin
Activated condition
External 0 interrupt P13/INT
When the next waveform is input to P13/INT pin
• Falling waveform (“H”→“L”)
• Rising waveform (“L”→“H”)
• Both rising and falling waveforms
Valid waveform
selection bit
I11
I12
(Note 1)
P13/INT
I13
I12
Falling
0
1
Rising
L10
One-sided edge
detection circuit
I11
0
1
Both edges
detection circuit
SNZI0 instruction
Skip
(Note 2)
Level detection circuit
Edge detection circuit
(Note 3)
EXF0
External 0
interrupt
Timer 1 count start
synchronization
circuit input
L11
0
Key-on wakeup input
1
Note 1: ^•
This symbol represents a parasitic diode on the port.
2: When I12 is 0, “L” level is detected.
When I12 is 1, “H” level is detected.
3: When I12 is 0, falling edge is detected.
When I12 is 1, rising edge is detected.
Fig. 17 External interrupt circuit structure
(1) External 0 interrupt request flag (EXF0)
External 0 interrupt request flag (EXF0) is set to “1” when a valid
waveform is input to P13/INT pin.
The valid waveforms causing the interrupt must be retained at their
level for 4 clock cycles or more of the system clock (Refer to Figure
16).
The state of EXF0 flag can be examined with the skip instruction
(SNZ0). Use the interrupt control register V1 to select the interrupt or
the skip instruction. The EXF0 flag is cleared to “0” when an interrupt
occurs or when the next instruction is skipped with the skip instruc-
tion.
• External 0 interrupt activated condition
External 0 interrupt activated condition is satisfied when a valid
waveform is input to P13/INT pin.
The valid waveform can be selected from rising waveform, falling
waveform or both rising and falling waveforms. An example of how
to use the external 0 interrupt is as follows.
➀ Set the bit 3 of register I1 to “1” for the INT pin to be in the input
enabled state.
➁ Select the valid waveform with the bits 1 and 2 of register I1.
➂ Clear the EXF0 flag to “0” with the SNZ0 instruction.
➃ Set the NOP instruction for the case when a skip is performed
with the SNZ0 instruction.
➄ Set both the external 0 interrupt enable bit (V10) and the INTE
flag to “1.”
The external 0 interrupt is now enabled. Now when a valid wave-
form is input to the P13/INT pin, the EXF0 flag is set to “1” and the
external 0 interrupt occurs.
Rev.1.02 2006.12.22 page 23 of 140
REJ03B0147-0102