JN516X Datasheet, PDF (71/94 Pages) NXP Semiconductors – IEEE802.15.4 Wireless Microcontroller

Radio Parameters: 2.0-3.6V, -40ºC
Parameter
Min
Typical
Max
Unit
Receiver Characteristics
Receive sensitivity
-93.0
-96.0
dBm
Maximum input signal
+10
dBm
Adjacent channel
rejection (-1/+1 ch)
19/34
dBc
[CW Interferer]
Alternate channel
rejection (-2/+2 ch)
[TBC]
40/44
dBc
[CW Interferer]
[TBC]
Other in band rejection
47
dBc
2.4 to 2.4835 GHz,
excluding adj channels
Out of band rejection
49
dBc
Spurious emissions
(RX)
Intermodulation
protection
RSSI linearity
Transmit power
Output power control
range
Spurious emissions
(TX)
EVM [Offset EVM]
Transmit Power
Spectral Density
dBm
<-70
-64
-60
39
dB
-4
+4
dB
Transmitter Characteristics
0
+2.00
dBm
-35
dB
-40
13 [2.5]
-38
<-70
<-70
-20
dBm
%
dBc
Notes
Nominal for 1% PER, as per
802.15.4 Section 6.5.3.3
For 1% PER, measured as
sensitivity
For 1% PER, with wanted signal
3dB, above sensitivity. (Note1,2)
(modulated interferer)
For 1% PER, with wanted signal
3dB, above sensitivity. (Note1,2)
(modulated interferer)
For 1% PER with wanted signal
3dB above sensitivity. (Note1)
For 1% PER with wanted signal
3dB above sensitivity. All
frequencies except wanted/2 which
is 8dB lower. (Note1)
Measured conducted into 50ohms
30MHz to 1GHz
1GHz to 12GHz
For 1% PER at with wanted signal
3dB above sensitivity. Modulated
Interferers at 2 & 4 channel
separation (Note1)
-95 to -10dBm.
Available through Hardware API
In three 12dB steps (Note3)
Measured conducted into 50ohms
30MHz to 1GHz,
1GHz to12.5GHz,
The following exceptions apply
1.8 to 1.9GHz & 5.15 to 5.3GHz
At maximum output power
At greater than 3.5MHz offset, as
per 802.15.4, Section 6.5.3.1
© NXP Laboratories UK 2013
JN-DS-JN516x v1.1 Production
71